Temporary Works Design – Above Ground

Temporary Works Design Training

Overview

Temporary Works is a particular source of risk on site, both from a safety and commercial point of view. Following a series of collapses in the 1970’s, the Bragg report and subsequently BS 5975 were produced, to assist designers and users of temporary works.

The industry still recognises today, along with the HSE, the risks associated with temporary works with the competency of the designer being a key point of concern

Correct design, co-ordination and execution of temporary works is essential to the overall requirement of any project to be completed in accordance with safety, time and budget, health and environmental constraints.

Temporary Works design is different from design of permanent works in several respects, including:

• Importance of understanding site operations and constraints
• Need to work closely with the contractor
• Importance of erection methods and co-ordination
• Formwork and Falsework in particular are generally loaded to their full capacity.

Temporary Works therefore has a code of practice BS5975 that in addition to technical issues also contains a section on procedural control and co-ordination.

This course is one of two courses on temporary works design, focussing on works above ground, and is complemented by a similar course focussing on works below ground.

The course encourages the exchange of experience by means of delegate comments and questions, group discussion, and team exercises. The courses are equally suitable for contractors, consultants and specialist sub-contractors.

The tutor is a highly experienced Chartered Civil, with 20 years experience of temporary works with major national contractors and a specialist temporary works consultancy.

The course has been developed for:

• Design engineers wishing to specialise in temporary works as a general introduction to the basics of the subject
• Temporary Works Co-ordinators, managers, site engineers, estimators and planners with a general knowledge of engineering design wanting an understanding of design of basic temporary works for which they may be responsible

Objectives

• Ability to design / check minor temporary works schemes
• Knowledge of how site conditions affect the design of temporary works
• Knowledge of the processes involved in temporary works design
• Knowledge of procedures in temporary works design, including temporary works coordination, in accordance with BS5975

Outline:

Introduction and course expectations

Procedures

• BS5975
• The roles in temporary works assurance
• Other current guidance

Legal Aspects

• Designers duties under CDM regulations

Wall & column formwork

• Types of formwork in common use
• Calculation of lateral pressures
•  Ties
• One-sided formwork
• Team Exercise

Falsework & soffit formwork

 Types of formwork in common use
 Calculation and identification of loads
 Team exercise

Scaffold design

• Basic scaffolds, and their limitations
• Introduction to TG20
• Calculations for scaffolds
• Tying and Bracing
• Working Platforms
• Introduction to Special Scaffolds
• Forming openings in masonry walls
• Types of wall
• Needling
• Pynford stools

Summary and Close

Timings

The course starts at 09:00 and fishes at 17:00 with refreshment breaks mid-morning, lunchtime and mid-afternoon.

All timings except the start time are approximate and may be adjusted to suit natural breaks in the lesson

Duration:1 Day

Cost:£300 + VAT

Temporary Works Design above ground training Scotland, Glasgow, Edinburgh, Aberdeen, Inverness and closed onsite courses available throughout the UK